Free lesson preview
Controlled vs. uncontrolled airspace: the classes at a glance
The big picture of U.S. airspace: what makes airspace controlled, where Classes A through G start and stop, and the one Part 107 rule that decides when you need ATC authorization.
Every flight you make happens inside some class of airspace. For a Part 107 remote pilot, the class matters for one main reason: it tells you whether you need permission from Air Traffic Control (ATC) before you launch. This lesson gives you the whole map at once. The next three lessons fill in the detail.
Two families: controlled and uncontrolled
The U.S. airspace system uses six classes: A, B, C, D, E and G. (There is no Class F in the United States.)
- Controlled airspace is airspace with defined dimensions where ATC provides service. The AIM uses "controlled airspace" as the general term for Classes A, B, C, D and E.
- Uncontrolled airspace is Class G, everything that has not been designated as A through E.
"Controlled" describes the service ATC provides to manned aircraft. It does not mean "you need permission to fly a drone here." That distinction trips up a lot of test takers, and the next section explains why.
The classes at a glance
Try the interactive diagram below. Click each class to see its usual floor, ceiling and what Part 107 requires.
| Class | Where it usually is | Typical floor | Typical ceiling | ATC authorization for Part 107? |
|---|---|---|---|---|
| A | High-altitude airspace | 18,000 ft MSL | FL600 | Not relevant (far above any Part 107 flight) |
| B | Around the busiest airports | Surface (higher for outer shelves) | About 10,000 ft MSL | Yes |
| C | Around busy airports with radar approach control | Surface (shelf no lower than 1,200 ft above the airport) | About 4,000 ft above the airport | Yes |
| D | Around airports with an operating control tower | Surface | About 2,500 ft above the airport | Yes, while in effect |
| E (surface area) | Around certain airports | Surface | Overlying airspace | Yes |
| E (all other) | Almost everywhere else, above a floor | 700 ft AGL, 1,200 ft AGL, or 14,500 ft MSL | Up to, not including, 18,000 ft MSL | No |
| G | Close to the ground, away from busy airports | Surface | Floor of the overlying Class E | No |
Three things to notice:
- Airport classes are built around traffic. The busier the airport, the bigger and taller its airspace: B is the largest, then C, then D.
- "Typical" really means typical. Every Class B, C and D area is individually designed to fit the local airport. You always read the actual dimensions from the chart, which you will learn in Module 4.
- Class E is the most common controlled airspace, and most of it is above you. Across most of the country, Class E begins at 700 ft or 1,200 ft above ground level (AGL). A drone at or below 400 ft AGL stays underneath it, in Class G.
The one rule that decides: §107.41
Part 107 has a single, short rule about airspace classes. 14 CFR §107.41 says no person may operate a small unmanned aircraft "in Class B, Class C, or Class D airspace or within the lateral boundaries of the surface area of Class E airspace designated for an airport unless that person has prior authorization from Air Traffic Control (ATC)."
Break that down and you get a simple test:
- Is any part of the flight inside Class B, C or D? You need authorization.
- Is any part of it inside a Class E surface area for an airport? You need authorization.
- Is the whole flight in Class G, or in Class E that starts above the surface? You need no ATC authorization. Every other Part 107 rule still applies.
Notice what the rule does not say. It sets no distance from an airport (no "5-mile rule") and gives no exemption for flying low. A flight at 50 ft AGL inside Class D needs authorization just as much as a flight at 390 ft AGL.
Weather minimums do not change with the class
Manned VFR pilots memorize a different set of visibility and cloud-clearance numbers for each class (14 CFR §91.155). Part 107 replaces all of that with one set of numbers that apply everywhere (§107.51):
- At least 3 statute miles of flight visibility, observed from the control station.
- At least 500 ft below clouds.
- At least 2,000 ft horizontally from clouds.
So Class G is not "easier" on weather for a drone, and Class B is not "stricter." If a question offers you a class-specific Part 107 weather minimum, it is a distractor.
A three-step habit for every airspace question
Whether you are planning a real job or answering a test question, run the same three steps:
- Find where you are. Locate the site on the chart and identify every boundary it falls inside.
- Find the floor and ceiling of each boundary. Chart labels for Class B, C and D are in feet MSL (above mean sea level).
- Convert your planned altitude to the same reference. Add your planned height AGL to the ground elevation to get MSL, then compare. If your flight reaches into the airspace, that airspace applies.
Step 3 is where most mistakes happen. A Class C shelf that begins at 2,100 ft MSL might sit only a few hundred feet above high ground. Lesson 2 and Module 4 drill this conversion.
Summary
- Controlled airspace is Classes A, B, C, D and E. Uncontrolled airspace is Class G. The U.S. has no Class F.
- Under §107.41 you need prior ATC authorization in Class B, C, D, or a Class E surface area for an airport, at any altitude. No distance rule and no low-altitude exemption exist.
- Most Class E starts at 700 or 1,200 ft AGL, so a drone at or below 400 ft AGL is usually in Class G there and needs no authorization.
- Part 107 weather minimums (3 SM visibility, 500 ft below and 2,000 ft horizontally from clouds) are the same in every class.
- Chart altitudes for B, C and D are MSL. Always convert your AGL altitude before comparing.
Official sources
- 14 CFR §107.41 — Operation in certain airspace
- 14 CFR §107.51 — Operating limitations for small unmanned aircraft
- FAA Aeronautical Information Manual, Chapter 3, Section 2 — Controlled Airspace
- FAA Aeronautical Information Manual, Chapter 3, Section 3 — Class G Airspace
- FAA Aeronautical Chart Users' Guide (VFR Terms and Symbols)
- FAA Remote Pilot – Small Unmanned Aircraft Systems Study Guide (FAA-G-8082-22)